YGG YGGB 硅橡膠電力電纜

一、生產執行標準(Executive standard):TICW/04-2009

二、使用特性

1、額定電壓UO/U:600/1000V。

1: Rated voltage UO/U:600/1000V

2、電纜允許工作溫度范圍-60℃～+180℃。

2 : W o r k in g te m p e r at ure all o we d b y c a b l e is-60℃～+180℃.

3、短路時(zui長持續間不超過5S)電纜導體的zui高溫度不超過250℃。

3: Max temperature of cable conductor is no more than 250℃ during short circuit(The longest lasting time isno more than 5s.)

4、電纜敷設溫度應不低于-20℃。

4.Temperature for installing is no less than -20℃.

5、電纜的彎曲半徑如下：?jiǎn)涡倦娎|彎曲半徑不小于電纜外徑的15D；（D-電纜外徑）；

三芯電纜彎曲半徑不小于電纜外徑的12D。

5.Bending radius of cable as follows:It is no less than 15 times that of cable outer diameter for cable with single coreIt is no less than 12 times that of cable outer diameter for cable with three cores

三、電纜型號名稱(Type and Description)

  1.YGGP  

 2.  YGV

 3.  YGG22

1、成品電纜導體20℃時直流電阻:應滿足GB/ T3956標準要求，成品電纜導電線芯的直流電阻，換算到電纜長度為1m，標稱截面為1mm2和溫度為20℃時，銅芯線芯應不大于0.0184Ω。

 2、成品電纜絕緣線芯的絕緣電阻：成品電纜絕緣線芯的絕緣電阻，換算到電纜長度為1km和溫度為20℃時，導電線芯

截面在50mm2及以下的應不小于50MΩ,70~185mm2的應不小于35MΩ。

 3、成品電纜應經受工頻交流試驗電壓3000V、5min電壓試驗，絕緣無擊穿。

Technical parameter

1. DC resistance of finished cable conductor at 20℃ shall meet the requirement of GB/T3956 standard. Con-ductive core DC resistance of finished cable is no more than 0.0184Ω for cable with cross section 1mm2 under the condition that cable length is 1m and temperature is 20℃.

   2.Insulated resistance of finished cable insulatedconductor will be no less than 50MΩ for cable with con-ductive core cross section 50mm2 or lower and 35 MΩfor cable with conductive core cross section 70 ~185mm2 under the condition that cable length is 1km and tempera-ture is 20℃.

 3: Finished c able shall bear A .C voltage test of 350 0V under power frequency for 5 minutes without puncture of insulation.

五、規格范圍 Specification

電纜規格用導體芯數×導體標稱截面mm2表示，如表2 ：

（ “core number * nominal cross section area” standsfor cable specification. Please see the following table 2）

防水電纜  電線電纜   補償電線電纜  熱電偶  耐高溫硅橡膠電纜

MC MCP采煤機軟電纜  MY MYP煤礦移動軟電纜 YGGB YFFB耐高溫扁平電纜

WDZAN-YJY WDZA-YJY低煙無鹵阻燃耐火環保型電力電纜 交聯聚乙烯電力電纜

六、交貨長度

允許根據雙方協議長度交貨；長度計量誤差不超過±0.5%。